Set-Jms-Notifier-Configuration
Configures the settings of the JMS notifier
Synopsis
asadmin [asadmin-options] set-jms-notifier-configuration [--help]
[--target target]
[--enabled={false|true}]
[--dynamic={false|true}]
[--filter={INFO|WARNING|SEVERE}]
[--contextFactoryClass className]
[--connectionFactoryName connectionFactoryName]
[--queueName queueName]
[--url url]
[--userName userName]
[--password password]
Description
This command can be used to configure the behaviour of the JMS notifier in Payara Server Full Profile.
Options
asadmin-options:
Options for the asadmin utility. For information about these options, see the asadmin help page.
--help:
-?:
Displays the help text for the subcommand.
--target:
This option helps specify the target on which you are configuring the JMS notifier. Valid values are:
server;;
Applies to the default server instance. This is the default value.
cluster_name;;
Applies to every server instance in the cluster.
instance_name;;
Applies to a specified sever instance.
--enabled:
Defaults to false. Enables or disables the notifier
--dynamic:
Defaults to false. When set to true, applies the changes without a server restart.
+
Otherwise, a restart is required.
--filter:
Defaults to WARNING. The notifier only responds to events at or above this level. (INFO, WARNING, SEVERE)
--contextFactoryClass:
Defines the naming context factory class used to provision the JMS resources required to send the notification events.
+
NOTE: The referenced class name should point to a valid implementation of javax.naming.spi.InitialContextFactory and should be located in the server’s classpath.
+
TIP: In most cases, using the default context factory class (com.sun.enterprise.naming.SerialInitContextFactory) is enough.
--connectionFactoryName:
Defines the JNDI name of an existing JMS connection factory which will be used to send the notification messages.
--queueName:
Defines the physical name of an existing JMS queue destination used to send the messages to.
--url:
Defines the URL of a JMS broker server that will handle the sending and reception of the notification message.
--userName:
Defines the user that will authentication to the JMS broker server (if required).
--password:
Defines the password credential of the user that will authentication to the JMS broker server (if required).
Examples
Example 1 Enable the JMS Notifier and Configure it using OpenMQ
This example enables the JMS notifier and sets it up to connect to the default, local OpenMQ broker server and use a queue named testQueue:
asadmin set-jms-notifier-configuration --dynamic=true --enabled=true --contextFactoryClass=com.sun.enterprise.naming.SerialInitContextFactory --connectionFactoryName=jms/__defaultConnectionFactory --queueName=testQueue --url=localhost:7676 --username=testUser --password=******** --target=server-config